![background image](http://html.mh-extra.com/html/siemens/simpro-100/simpro-100_instruction-manual_383121205.webp)
SIMPRO-100
SIMPRO-PC Compatibility Features
D
PRIM-2400C
203
D.11
CME T Command
xxxxxx
Display thermal meter data in compressed ASCII
format by typing
CME T <CR>
. The relay
replaces the items in italics with the actual relay
data.
The SIMPRO-100 Relay sends:
where:
•
"THM CAP(%)" is the thermal model
thermal capacity used in percent.
•
"RTD TC(%)" is the RTD estimated
thermal capacity used in percent.
•
"CALC TIME" is the calculated time to
thermal trip in seconds.
•
"MINUTES" is the number of minutes
since the last motor start.
•
"STARTS" is the number of motor starts in
the past hour.
RTD labels are replaced with “*” if RTDs are not
supported or enabled. RTD locations and
temperature designators are setting dependent.
RTD thermal capacity is reported as 0 if RTDs are
not supported or enabled.
Summary of Contents for SIMPRO-100
