SINAMICS CONNECT
Operating Instructions, 10/2018, A5E45421408
91
Appendix
A
A.1
Assembly of cable terminals on the device side
Assembling the terminals for cable without ferrule
Solid conductor (cross section: 0.2 mm
2
to 1 mm
2
)
Stranded conductor (cross section: 0.5 mm
2
to 1 mm
2
)
1.
Remove the specified length (see illustration) of the outer sheath of the cable, and make a PE conductor from the
braided shield.
2.
Strip the specified length (see illustration) of the insulation at the end of the wire.
