SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
543
2 Parameters
2.2 List of parameters
41:
12-pulse serial, firing angle from the master
42:
12-pulse serial with sequential phase control
Dependency:
Refer to: p51795
Note:
Comments, the same as for p51799
Description:
Sets the position of the power unit in converter topology 2.
Value:
0:
Parallel interface not active
1:
Power unit independent/CUD right
11:
6-pulse parallel master
12:
6-pulse parallel slave
13:
6-pulse parallel slave/replacement master
21:
12-pulse parallel master
22:
12-pulse parallel slave
23:
12-pulse parallel, slave parallel to master
24:
12-pulse parallel, slave parallel to slave
31:
6-pulse serial master
32:
6-pulse serial slave
33:
6-pulse serial parallel to master
34:
6-pulse serial parallel to slave
35:
6-pulse serial master, slave is a diode bridge
41:
12-pulse serial master
42:
12-pulse serial slave
43:
12-pulse serial parallel to master
44:
12-pulse serial parallel to slave
45:
12-pulse serial master, slave is a diode bridge
Dependency:
Refer to: p51799
Note:
Comments, the same as for p51800
Description:
Sets the switch-on threshold and hysteresis for the phase sequence control.
The values are referred to the rated device current r50072[1].
Index:
[0] = Switch-on threshold
[1] = Hysteresis
Dependency:
Refer to: p51799
Note:
The switch-off threshold is calculated as follows:
Switch-off threshold = switch-on threshold - hysteresis
p51795
Topology switchover power unit topology position 2 / Topo_sw pos 2
DC_CTRL
Can be changed:
T
Calculated:
-
Access level:
2
Data type:
Integer16
Dyn. index:
-
Func. diagram:
9360
P-Group:
-
Unit group:
-
Unit selection:
-
Not for motor type:
-
Scaling:
-
Expert list:
1
Min Max
Factory
setting
0 45
0
p51797[0...1]
Sequential phase control switch-on threshold/hysteresis / Seq ph ctr on/hys
DC_CTRL
Can be changed:
T
Calculated:
-
Access level:
3
Data type:
FloatingPoint32
Dyn. index:
-
Func. diagram:
6860
P-Group:
-
Unit group:
-
Unit selection:
-
Not for motor type:
-
Scaling:
PERCENT
Expert list:
1
Min Max
Factory
setting
5 [%]
100 [%]
[0] 35 [%]
[1] 30 [%]
Summary of Contents for SINAMICS DCM
