Overview of the SINAMICS G115D drive
2.3 Directives and standards
SINAMICS G115D distributed drive
30
Operating Instructions, 12/2020, FW V4.7 SP13, A5E48681219B-002
2.3
Directives and standards
The following directives and standards are relevant for the SINAMICS G115D converters and
the configurable SIMOGEAR 2KJ8 geared motors:
European Low Voltage Directive
The converters and motors fulfill the requirements stipulated in the Low-Voltage Directive
2014/35/EU, if they are covered by the application area of this directive.
European Machinery Directive
The converters and motors fulfill the requirements stipulated in the Machinery Directive
2006/42/EC, if they are covered by the application area of this directive.
However, the use of the converters and motors in a typical machine application has been
fully assessed for compliance with the main regulations in this directive concerning health
and safety.
Directive 2011/65/EU
The converter and motors fulfill the requirements of Directive 2011/65/EU relating to the
restriction of the use of certain hazardous substances in electrical and electronic devices
(RoHS).
European EMC Directive
The compliance of the converters and motors with the regulations of the Directive
2014/30/EU has been demonstrated by full compliance with the IEC/EN 61800-3.
EMC requirements for South Korea
The converters and motors with the KC marking on the rating plate satisfy the EMC
requirements for South Korea.
Underwriters Laboratories (North American market)
Converters and motors provided with the test symbol displayed fulfill the requirements
stipulated for the North American market as a component of drive applications, and are
appropriately listed.
Eurasian conformity
The converters and motors comply with the requirements of the Russia/Belarus/Kazakhstan
customs union (EAC).
Australia and New Zealand (RCM formerly C-Tick)
The converters and motors showing the test symbols fulfill the EMC requirements for
Australia and New Zealand.
