Installing and putting a TIM into operation
4.6 Configuring a TIM and setting parameters
Station control system
170
System Manual, 07/2009, C79000-G8976-C178-07
Figure 4-31 Networked system with parameter assignment dialogs for network and network nodes opened
The properties of the two classic WANs are specified in a parameter assignment dialog for
dedicated lines and for dial-up networks. The relevant dialog can be opened simply by
double-clicking on the corresponding network. To set the parameters for the various network
nodes, you also double-click on the connecting line between the network and the node to
open the relevant parameter assignment dialog.
Setting parameters for SINAUT connections
Once the system is networked and the properties for the networks or network nodes have
been specified, you can start the SINAUT ST7 configuration tool to complete parameter
assignment. This tool is used, on the one hand, to automatically identify which connections
are possible from the PC of the control center to the CPU and from CPU to CPU and to
make them available for selection. On the other hand, all CPUs, PC(s) of the control center
and all TIMs are also assigned a SINAUT subscriber number that is unique throughout the
system.
