Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
10860
[Channel %1: ] Block %2 feedrate not programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Cause:
A traversing velocity has not been programmed for the displayed traversing block.
Feed F or FZ:
With the traversing velocity defined by feed F or FZ, F or FZ was not reprogrammed after the feed type changed, for
example linear feed G94 after revolutional feedrate G95 F or G95 FZ.
Modal feed FRCM:
With modal traversing velocity FRCM defined for rounding RND or chamfering CHF, feed FRCM was not reprogrammed
after the feed type changed, for example linear feed G94 after revolutional feedrate G95, or revolutional feedrate G95 F
after tooth feedrate G95 FZ.
Note:
Feed FRCM also has to be reprogrammed when the feed type changes if the current traversing block does not contain
chamfering CHF or rounding RND, but the feed FRCM was programmed active, that is unequal to 0, before the feed type
changed.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy:
Program feedrate in accordance with the interpolation type.
- G93: The feedrate is specified as a time-reciprocal value under address F in [rev/min].
- G94 and G97: The feedrate is programmed under address F in [mm/min] or [m/min].
- G95: The feedrate is programmed as revolutional feedrate under address F in [mm/revolution]
or under the address FZ in [mm/tooth].
- G96: The feedrate is programmed as cutting rate under address S in [m/min]. It is derived from the current spindle speed.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
10861
[Channel %1: ] Block %3 velocity of positioning axis %2 is zero
Parameters:
%1 = Channel number
%2 = Axis
%3 = Block number, label
Explanation:
No axis velocity has been programmed and the positioning velocity set in the machine data is zero.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
Remedy:
Please inform the authorized personnel/service department. Enter a different velocity in MD32060 $MA_POS_AX_VELO.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
10862
[Channel %1: ] Block %2 master spindle also used as path axis
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
A contour has been programmed that also includes the master spindle as contouring axis. However, the velocity of the
contour is derived from the rotational speed of the master spindle (e.g. G95).
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
127
