Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14045
[Channel %1: ] Block %2 error in tangential circle programming
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The alarm may have the following causes:
The tangent direction is not defined for tangent circle, e.g. because no other travel block has been programmed before
the current block. No circle can be formed from start and end point as well as tangent direction because - seen from the
start point - the end point is located in the opposite direction to that indicated by the tangent.
It is not possible to form a tangent circle since the tangent is located perpendicular to the active plane.
In the special case in which the tangent circle changes to a straight line, several complete circular revolutions were
programmed with TURN.
Reaction:
Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy:
Modify part program.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14048
[Channel %1: ] Block %2 wrong number of revolutions in circle programming
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
In the circle programming, an inadmissible number of full revolutions has been specified.
The number of revolutions must not be negative and must not be greater than 1000000.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Programm
continuation:
Clear alarm with the RESET key. Restart part program
14050
[Channel %1: ] Block %2 nesting depth for arithmetic operations exceeded
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
For calculating arithmetic expressions in NC blocks, an operand stack with a fixed set size is used. With very complex
expressions, this stack can overflow. This may also occur with extensive expressions in synchronized actions.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Divide up complex arithmetic expressions into several simpler arithmetic blocks.
Programm
continuation:
Clear alarm with NC START or RESET key and continue the program.
14051
[Channel %1: ] Block %2 arithmetic error in part program
Parameters:
%1 = Channel number
%2 = Block number, label
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
187
