Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Modify feed parameter.
Programm
continuation:
Clear alarm with the RESET key. Restart part program
61004
[Channel %1: ] Block %2: Incorrect configuration of geometry axes
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
--
Programm
continuation:
Clear alarm with the RESET key. Restart part program
61005
[Channel %1: ] Block %2: 3rd geometry axis not available
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
With an application on the turning machine with no Y-axis in the G18 plane.
Remedy:
Check parameter on cycle call.
61006
%[[Channel %1: ] Block %2: %]Tool radius too large
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The tool radius is too large for machining.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select a smaller tool.
Programm
continuation:
Clear alarm with the RESET key. Restart part program
61007
[Channel %1: ] Block %2: Tool radius too small
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The tool radius is too small for machining.
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Select a larger tool.
Programm
continuation:
Clear alarm with the RESET key. Restart part program
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Diagnostics Manual
364
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2