Remedy:
Calibrate the probe before measuring.
Check the number of the probe calibration data field (calibration data record) in parameter S_PRNUM.
Note planes G17, G18 and G19. Only G18 is permitted for workpiece measurement when turning.
Check: Setting data 54611 $SNS_MEA_WP_FEED[S_PRNUM-1] > 0 after calibration
61342
[Channel %1: ] Block %2: Upgrade NCK software version
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
Upgrade NCU software version.
61343
%[[channel %1: ] block %2:%]Tool does not exist: %4
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
Check tool name.
61344
[Channel %1: ] Block %2: Several tools are active
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
Remove tool from another spindle.
61345
[Channel %1: ] Block %2: D number of tool offset, too many digits
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
Reduce the D number in _KNUM, check software or MD of flat D number.
61346
[Channel %1: ] Block %2: Distance between starting point and measuring point is smaller than or
equal to zero
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
: - Parameter _SETV[0] or _SETV[1] is empty or less than 0.
For 840D sl - as from SW 2.7 and for 828D - as from SW 4.4:
: - Parameter X1 or X2 is empty or less than 0.
Programm
continuation:
Clear alarm with the RESET key. Restart part program
61347
[Channel %1: ] Block %2: Angle 1st edge - 2nd edge equals 0
Parameters:
%1 = Channel number
%2 = Block number, label channel number
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Diagnostics Manual
436
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2