Remedy:
After positioning the orientable tool carrier, tool lengths L1, L2 and L3 are not parallel to the geometry axes.
Check the positioning behavior of the rotary axes (blocking) of the tool carrier.
61443
[Channel %1: ] Block %2: Advance angle %4 or greater/less than +/-90° or +/-120°
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
For 840D sl - up to SW 2.6 SP1 and for 828D - up to SW 4.3:
- Check the value in the parameter advance angle _INCA!
- If 3-point measurement is selected, _INCA must not be greater/less than +/-120°, and with 4-point measurement
_INCA must not be greater/less than +/-90°.
- The advance angle _INCA must always be parameterized unequal to "zero".
For 840D sl - aa from SW 2.7 and for 828D - as from SW 4.4:
- Check the value in the parameter advance angle alpha 1!
- If 3-point measurement is selected, alpha 1 must not be greater/less than +/-120° and with 4-point measurement,
alpha 1 must not be greater/less than +/-90°!
- The advance angle alpha 1 must always be parameterized unequal to "zero".
61444
[Channel %1: ] Block %2: Current measuring speed is not identical to the calibration speed
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
The relevant calibration speed is also stored in each calibration data record.
The current measuring speed with feedrate override of 100% is not equal to the calibration speed.
After calibration, the calibration speed value must be in the following setting data.
For workpiece measurement:
SD 54611 $SNS_MEA_WP_FEED[S_PRNUM-1] > 0
For tool measurement:
SD 54636 $SNS_MEA_TP_FEED[S_PRNUM-1] > 0 for calibration in the machine coordinate system
SD 54651 $SNS_MEA_TPW_FEED[S_PRNUM-1] > 0 for calibration in the workpiece coordinate system
Recalibrate probe (adjust) or specify new S_PRNUM.
61445
[Channel %1: ] Block %2: Check holder angle
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
Check the entry for the holder angle in the tool offset.
For cutting edge positions 1-4, the holder angle must be greater than or equal to 90° and less than 180°,
for cutting edge positions 5-8, it must be greater than 0° and less than 90°.
61446
[Channel %1: ] Block %2: Check insert angle and clearance angle
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
Remedy:
Check the entry for the insert angle / clearance angle in the tool offset!
61501
[Channel %1: ] Block %2: Simulation is active
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Diagnostics Manual
450
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
