Remedy:
Check setup of swivel CYCLE800.
62186
[Channel %1: ] Block %2: No swiveling in JOG -> WO G%4 active and total basic WO (G500)
contain rotations
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
On swiveling in JOG no rotation can be written to the work offset WO,
if rotations are already contained in the total basic WO or in the basic reference
Error 62186 message can be masked -> see setting data 55410 $SCS_MILL_SWIVEL_ALARM_MASK
Remedy:
%4 number of the active work offset WO.
62187
[Channel %1: ] Block %2: Swiveling in JOG - G500 active and total basic WO or basic reference
contain rotations
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
During swiveling in JOG, it is not possible to write a rotation into the work offset WO,
if, with active G500, rotations are already contained in the total basic WO or in the basic reference
Error message 62187 can be masked -> see setting data 55410 $SCS_MILL_SWIVEL_ALARM_MASK
Remedy:
See notes for 62186 and 62187.
62200
[Channel %1: ] Block %2: Start spindle
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
Stop prior to thread machining, as the spindle is in stop position.
Remedy:
Start the tool spindle before machining the thread.
62201
[Channel %1: ] Block %2: Z offset does not influence the retraction planes.
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
The retraction planes refer to the workpiece. Therefore, programmable offsets do not influence the retraction planes.
Remedy:
Check that offset does not cause collision.
Then press NC Start.
62202
[Channel %1: ] Block %2: NOTICE: tool travels directly to machining!
Parameters:
%1 = Channel number
%2 = Block number, label
Explanation:
After block search a position is to be reached by direct approach.
Remedy:
Check whether the desired position can be reached without collision.
Then execute an NC start.
62300
[Channel %1: ] Block %2: Check number of empirical value memory
Parameters:
%1 = Channel number
%2 = Block number, label channel number
Explanation:
--
Reaction:
Alarm display.
Remedy:
Check setpoint value
Programm
continuation:
Clear alarm with the Delete key or NC START.
SINUMERIK 808D ADVANCED alarms
5.3 Cycle alarms
Diagnostics Manual
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2
505
