Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014
171
Explanation of the parameters
For an explanation of the parameters _RTP, _RFP, and _SDIS, refer to Section "Drilling, centering - CYCLE81 (Page 126)".
For an explanation of the parameters _MID, _FAL, _FALD, _FFP1, _FFD, and _DP, refer to Section "Milling a rectangular
pocket - POCKET3 (Page 197)".
_KNAME (name)
The contour to be milled is programmed completely in a subroutine. _KNAME defines the name of the contour subroutine.
●
Defining the contour as a subroutine
_KNAME = name of the subroutine
–
If the subroutine already exists, specify a name, and then continue.
–
If the subroutine does not yet exist, specify a name and then press the following softkey:
A program with the entered name is created and the program automatically jumps to the contour editor.
–
Use the following softkey to confirm your input and return to the screen form for this cycle.
●
Defining the contour as a section of the called program
KNAME = name of the starting label: name of the end label
Input:
–
If the contour is not yet described, specify the name of the starting label and press the following softkey. If the contour
is already described (name of starting label: name of end label), directly press the following softkey:
The control system automatically creates starting and end labels from the name entered and the program jumps to
the contour editor.
–
Use the following softkey to confirm your input and return to the screen form for this cycle:
