Drive commissioning (SIMODRIVE)
10.1 SIMODRIVE 611 universal/E, POSMO CD/CA and SI
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
349
References:
For detailed information on commissioning of SIMODRIVE 611 universal drives, refer to:
/FBU/ SIMODRIVE 611 universal function description, Chapter "Parameterization of the
Module", Parameter definition via display and operator unit and Chapter "Settings in
PROFIBUS DP Master", commissioning
10.1.4
Setting PROFIBUS address (SIMODRIVE POSMO SI/CD/CA)
For SimoCom U to be able to enter online operation with the SIMODRIVE drives connected
to the PROFIBUS, the PROFIBUS address specified in the S7 project (see Chapter "Create
SIMATIC S7 Project" (Page 160)) must be set on DP slave POSMO SI/CD/CA in question
using the DIL switches of the PROFIBUS unit in question.
O
N=
1
6ZLWFKVHWWLQJ
2))
UHVHUYHG
7HUPLQDWLRQUHVLVWRUDFWLYH
21
21
352),%86DGGUHVV
21
1RWH
7KHYDOLGVHWWDEOHDGGUHVVHVDUHWR
7KHVHWDGGUHVVLVUHDGE\326026,&'&$DQGGLVSOD\HGXVLQJ
3352),%86QRGHDGGUHVV
21
([DPSOH352),%86DGGUHVV
7HUPLQDWLQJUHVLVWRU
LQDFWLYH 2))
Figure 10-2 Setting the PROFIBUS address and terminating resistor
NOTICE
To set the PROFIBUS address and terminating resistor it is necessary to remove the
PROFIBUS unit.
References:
For detailed information on commissioning of SIMODRIVE POSMO CD/CA and SI universal
drives, refer to:
/POS3/ SIMODRIVE POSMO SI/CD/CA User Manual, Chapter "Connecting the PROFIBUS
unit"
