NC Commissioning with HMI Advanced
11.2 Machine and setting data
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
359
11.2.1
Display and input
Machine data screen forms
To display and input machine data, appropriate screen forms are provided.
The screen forms are found on the HMI Advanced user interface at:
Area switchover > Commissioning > Machine data
NOTICE
For the input of machine data, the protection level 2 password (default "EVENING") has to
be set at the least.
Bit editor
To facilitate the input of machine data in the bit format (HEX), a bit editor is provided.
If the input cursor is on a machine data in HEX format in the MD list, you can call up the
editor by pressing the toggle key (in the middle of the cursor keys).
Figure 11-1 Input screen form of the bit editor for HEX machine data
You can set or reset single bits by clicking them with the mouse or by selecting them with the
cursor keys and then pressing the toggle key.
●
With the softkey OK, you can terminate the bit editor and accept the value set.
●
With the softkey Abort, you can quit the bit editor and discard the value set. The previous
setting is then valid again.
