NC Commissioning with HMI Advanced
11.2 Machine and setting data
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
361
Possible characters
Up to eight characters are possible in a password. We recommend that you restrict yourself
to the character set of the operator panel in selecting a password. Where a password
consists of less than eight characters, the additional characters are interpreted as blanks.
Default passwords
The following default passwords have been set for protection levels 1 to 3:
●
Protection level 1: SUNRISE
●
Protection level 2: EVENING
●
Protection level 3: CUSTOMER
NOTICE
A system power-up with loading the default machine data (after "Delete NC data", e.g.
using 840Di Startup) will reset the passwords to the default values.
These passwords should be changed to ensure effective access protection.
Redefining protection levels
The protection levels of machine and/or setting data can be modified both with respect to
complete machine or setting data ranges and for single data.
Data areas
Table 11-3 Protection levels: Machine data
Number Name
Name
MMC machine data ($MM_.... )
9200
USER_CLASS_READ_TOA
Read tool offsets
9201
USER_CLASS_WRITE_TOA_GEO
Write tool geometry
9202
USER_CLASS_WRITE_TOA_WEAR
Write tool wear data
9203
USER_CLASS_WRITE_FINE
Write Fine
9204
USER_CLASS_WRITE_TOA_SC
Change additive tool offsets
9205
USER_CLASS_WRITE_TOA_EC
Change tool setup offsets
9206
USER_CLASS_WRITE_TOA_SUPVIS
Change tool monitoring limit values
9207
USER_CLASS_WRITE_TOA_ASSDNO
Change D No. assigned to a tool edge
9208
USER_CLASS_WRITE_MAG_WGROUP change wear group magazine location/mag.
9209
USER_CLASS_WRITE_TOA_ADAPT
Tool adapter data
9210
USER_CLASS_WRITE_ZOA
Write settable zero offset
9213
USER_CLASS_OVERSTORE_HIGH
Extended overstore
9214
USER_CLASS_WRITE_PRG_CONDIT
Program control
9215
USER_CLASS_WRITE_SEA
Write setting data
9218
USER_CLASS_SELECT_PROGRAM
Program selection
