NC Commissioning with HMI Advanced
11.5 Axes and spindles
Manual
430
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
Position tolerance when switching over the encoder
It is possible to switch between the two encoders or position measuring systems of a
machine axis at any time. The permissible position difference between the two position
measuring systems is monitored.
●
MD36500 $MA_ENC_CHANGE_TOL (Max. tolerance on position actual value switchover)
Error reaction:
●
Alarm "25100 Measuring system cannot be switched over"
The requested switchover to another encoder is not carried out.
Causes of error/error handling:
●
The specified permissible tolerance is too small.
●
The measuring system to which you will switch over is not referenced.
Cycl. Monitoring the encoder position tolerance
The position difference between the two encoders or position measuring systems of a
machine axis is monitored with the following machine data:
●
MD36510 ENC_DIFF_TOL (measuring system synchronism tolerance)
Error reaction:
●
Alarm "25105 Measuring systems are not synchronous"
and stopping the machine axes using a speed setpoint ramp whose characteristic curve is
set in the following machine data:
●
MD36610 $MA_AX_EMERGENCY_STOP_TIME (braking ramp time when errors occur)
6723B/,0,7B&2856(
6723B/,0,7B),1(
326,7,21,1*B7,0(
67$1'67,//B'(/$<B7,0(
67$1'67,//B326B72/
&/$03B326B72/
352),%86
'3GULYHV
%UDNLQJ
UDPS
)ROORZLQJHUURU
167ಯ3RVLWLRQPHDVXULQJV\VWHPDFWLYH
(1&B=(52B021,725,1*
(1&B)5(4B/,0,7
$FWYDOSURFHVVLQJ
$FWYDOSURFHVVLQJ
(1&B&+$1*(B72/
(1&B',))B72/
$;B9(/2B/,0,7
6767,//B
9(/2B72/
&217285B72/
&RQWUROORRS
PRGHO
&75/287B/,0,7
$;B(0(5*(1&<B6723B7,0(
3RVLWLRQ
FRQWUROOHU
6SHHG
VHWSRLQW
6HWSRLQWVIURP
,QWHUSRODWRU
6HWSRLQW
SURFHVVLQJ
Figure 11-22 Monitoring for SINUMERIK 840Di sl