NC Commissioning with HMI Advanced
11.5 Axes and spindles
Manual
456
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
11.5.28
Spindle data
Machine data
Table 11-45 spindle: Machine data
Number
Name
Name
General ($MN_ ... )
12060
OVR_SPIND_IS_GRAY_CODE
Spindle override with Gray coding
12070
OVR_FACTOR_SPIND_SPEED
Evaluation of spindle speed override switch
12080
OVR_REFERENCE_IS_PROG_FEED
Override reference velocity
Axisspecific ($MA_ ... )
20090
SPIND_DEF_MASTER_SPIND
Initial setting for master spindle on channel
20092
SPIND_ASSIGN_TAB_ENABLE
Enabling/disabling of spindle converter
20118
GEOAX_CHANGE_RESET
Allow automatic geometry axis change
22400
S_VALUES_ACTIVE_AFTER_RESET
S function active after RESET
Axisspecific ($MA_ ... )
30300
IS_ROT_AX
Rotary axis
30310
ROT_IS_MODULO
Modulo conversion
30320
DISPLAY_IS_MODULO
Position display
31050
DRIVE_AX_RATIO_DENOM
Denominator load gearbox
31060
DRIVE_AX_RATIO_NUMERA
Numerator load gearbox
31122
BERO_DELAY_TIME_PLUS
BERO delay time in plus direction
31123
BERO_DELAY_TIME_MINUS
BERO delay time in minus direction
32200
POSCTRL_GAIN
KV factor
32810
EQUIV_SPEEDCTRL_TIME
Equivalent time constant speed control loop for feedforward
control
32910
DYN_MATCH_TIME
Time constant for dynamic matching
34040
REFP_VELO_SEARCH_MARKER
Reference point creep speed
34060
REFP_MAX_MARKER_DIST
Monitoring of zero mark distance
34080
REFP_MOVE_DIST
Reference point distance/destination point for distancecoded
system
34090
REFP_MOVE_DIST_CORR
Reference point offset/absolute offset, distancecoded
34100
REFP_SET_POS
Reference point value
34200
ENC_REFP_MODE
Homing mode
35000
SPIND_ASSIGN_TO_MACHAX
Assignment of spindle to machine axis
35010
GEAR_STEP_CHANGE_ENABLE
Gear stage change possible
35012
GEAR_STEP_CHANGE_POSITION
Gear stage change position
35020
SPIND_DEFAULT_MODE
Basic spindle setting
35030
SPIND_DEFAULT_ACT_MASK
Activate initial spindle setting
35040
SPIND_ACTIVE_AFTER_RESET
Spindle active after reset
35100
SPIND_VELO_LIMIT
Maximum spindle speed
35110
GEAR_STEP_MAX_VELO[n]
Maximum speed for gear change
35120
GEAR_STEP_MIN_VELO[n]
Minimum speed for gear change