NC Commissioning with HMI Advanced
11.8 Loadable compile cycles
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
481
11.8.3
Software version of a compile cycle
The software version of a compile cycle is displayed under:
HMI Advanced:
Diagnosis > Service Display > Version > NCU Version
Display (excerpt)
&&,QWHUIDFH9HUVLRQ
#1&.23,
/RDGHG&RPSLOH&\FOHV
,GHQWLILHU!9HUVLRQ!'DWHJHQHUDWHG!
&&VWDUWDGGUHVV
B1B,GHQWLILHU!9HUVLRQ!,)VWGLJLW!QGGLJLW!B(/)
&RGH $GUHVVH!
'DWD $GUHVVH!
Example:
_N_CLC407IF003001_ELF corresponds to software version: 4.7
Note
The display of code and data range start addresses of a compile cycle are provided for
diagnostics purposes only and have no significance in normal operation.
11.8.4
Constraints
The following checks are performed for all loaded compile cycles when the NC boots:
Interface versions
If the interface version of the compile cycle is incompatible with the interface version of the
NC system software, the following alarm is displayed:
●
Alarm "7200 Version_conflict_with_CCNCKInterfaceVersion".
dependencies
If one compile cycle has a functional dependency on another, and this has not been loaded
in the NC, the following alarm is issued:
●
Alarm "7200 CC<Identifier>_ELF Loader_problem_from_dFixup"
