Drive Optimization with HMI Advanced
14.3 Special functions
Manual
510
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
14.3
Special functions
Interface signals: Drive test, traversing request, traversing enable
In conjunction with the measuring functions, another 2 axis-specific interface signals are
provided:
●
DB31-DBx, DBX61.0 "Drive test traversing request"
●
DB31-DBx, DBX1.0 "Drive test, traversing enable"
In the PLC user program, therefore, an additional axis-specific traversing enable command
may be given in conjunction with measuring functions.
Activating
The interface signals are activated from the main menu of the appropriate measuring
function in the group "Drive test traversing enable", see following screen.
$[LV
$[LV
'LUHFW
VHOHFWLRQ
6WDUW
6WRS
$[LV
'ULYHದWHVWWUDYHOHQDEOH
:LWK3/&
7UDYHOUDQJH
0RQLWRULQJ
,QDFWLYH
8SSHUOLPLW
/RZHUOLPLW
PP
PP
6WDWXV
,QDFWLYH
$EVROXWHSRVLWLRQ
)LOH
IXQFWLRQV
'LVSOD\
8VHU
YLHZV
$[LV
0'
0HDVXULQJ
SDUDPHWHUV
0HDVXUH
PHQW
0HDVXUHGTXDQWLW\
3RVLWLRQDFWXDOYDOXHSRVLWLRQVHWSRLQWYDOXH
0HDVXUHPHQW
7\SHRIPHDVXUHPHQW
5HIIUHTXHQF\UHVSR
PP
<
3RVLWLRQFRQWUROORRSPHDVXULQJ
6WDUWXS
-RJ
?03)',5
7(6703)
529
&KDQQHOUHVHW
3URJUDPDERUWHG
Figure 14-1 Main menu: Position control loop measurement
Choose the type of traversing enable function from the selection list either by using the
toggle key or by double-clicking the selection with the right-hand mouse button:
●
without PLC
Traversing of the axis to be measured is enabled depending on the interface signals
typical for JOG mode (controller enable, pulse enable, etc.).
●
with PLC