PLC commissioning
6.3 Creating a SIMATIC S7 project
Manual
172
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
6.3.9
Networking PG/PC and PCU (Ethernet)
In order that external components connected via Ethernet, e.g. PG/PC with the SINAMICS
drive commissioning tool STARTER or SIMATIC Step 7, can communicate with SINUMERIK
840Di sl and SIMATIC drive units, the PG/PC must be linked to the PCU in the S7 project.
Implementation
Perform the following actions for networking:
1.
Start the NetPro configuration tool in HW Config.
'LVO
+:&RQILJ>6,180(5,.&RQILJXUDWLRQ6,1'LVO@
6WDWLRQ(GLW,QVHUW7DUJHW6\VWHP9LHZ7RROV:LQGRZ+HOS
352),%86'3PDVWHUV\VWHP
3/&'3$-
2.
From the selection list of the network objects, open Stations and insert a PG/PC into the
project (1).
1
$XVZDKOGHU1HW]REMHNWH
3URJUDPPLHUJHU¦W
RGHU3&
1HW3UR>6,1'LVO1HW]&?3URJUDP)LOHV??VSURM?6,1BVO@
1HWZRUN(GLW,QVHUW7DUJHW9LHZ7RROV:LQGRZ+HOS
)LQG
352),%86'3
352),%863$
352),1(7
6WDWLRQV
2WKHU6WDWLRQV
3*3&
6,0$7,&
6,0$7,&
6,0$7,&+6WDWLR
6,0$7,&'3
6,0$7,&3&6WDWL
6,0$7,&6
6XEQHW
7&3,3!5HDOWHN75/
5HDG\
Double-click on the inserted PG/PC station to open the Properties dialog box. Select the
"Interface (1)" tab. Click on "New..." to open the dialog box for creating a new interface (2).
Select "Industrial Ethernet (3)" as the interface type. Click OK to confirm the dialog.