06.03
10.10
NC/PLC diagnosis (840Di SW 2.3 and higher)
10-401
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
To accept the changes made press the soft key: Accept. The message box that
appears must also be confirmed by pressing the soft key: Accept.
Use the soft key: Abort to discard all changes and display the original settings
again.
2560 KB RAM / HD non–volatile
MPF0
Program aborted
ROV
CHAN1
AUTO
Start-up
Cancel
Signal level
Channel RESET
Diagnostics
Settings
Settings
non–volatile user memory
Signal source
Signal input for shutdown behavior
deactivated
–
Accept
Accepting the changes can result in the loss of NC user data.
Ensure that these data have been stored in a series machine start-up file.
1. Memory setting have been changed.
Changes do not become effective until after a full system reboot.
2. The shutdown behavior has been modified.
Wrong configuration results in data loss on loss of voltage.
Do you really want to make the changes now?
Settings
Fig. 10-39 Accepting settings
Notice
It is strongly recommended that you create a series machine start-up file as
described above prior to making any changes. See Chapter 14, page 14-449.
J
Accept changes
10 NC Start-Up with HMI Advanced
