06.03
10.5 Axes and spindles
10-312
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
The machine data
MD 20080: AXCONF_CHANAX_NAME_TAB[n] (name of the channel axis
in the channel)
is used to define the channel axis names.
Channel axis names must be unambiguous for the entire channel.
The machine data
MD 20060: AXCONF_GEOAX_NAME_TAB[n] (name of the geometry axis
in the channel)
is used to define the geometry axis names.
Geometry axis names must be unambiguous for the entire channel.
The axis names for channel and geometry axes are used in the parts program
for programming general traversing movements or to describe the workpiece
contour. The axis names are used for
path axes
synchronized axes
positioning axes
command axes
spindles
gantry axes
coupled-motion axes
master value coupling axes.
Table 10-17
Axis names: Machine data
Number
Identifier
Name/remarks
Ref.
General ($MN_ ...)
10000
AXCONF_MACHAX_NAME_TAB[n]
Machine axis name
Channel-specific ($MC_ ...)
20060
AXCONF_GEOAX_NAME_TAB
Geometry axis in the channel
20080
AXCONF_CHANAX_NAME_TAB
Name of channel axis/special axis in the channel
/FB/
Description of Functions, Basic Machine,
K2 Axes, Coordinate Systems, Frames, Actual-Value System for
Workpiece IWS,
Section: Axes
Channel axes
Geometry axes
Machine data
References
10 NC Start-Up with HMI Advanced
