06.03
10.5 Axes and spindles
10-339
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
10.5.16 Drift compensation
Digital drives are not subject to drift or compensate for it automatically.
Because ADI4 does not support acyclic services on the PROFIBUS DP, drift
compensation must be performed manually by entering the appropriate
compensation value in the axial machine data
MD36720 DRIFT_VALUE (basic drive value)
Manual drift compensation is performed with the axis at zero speed as follows:
Requirements
–
Zero speed of the axis
–
Axis enables pending
Speed-controlled axis
The drift causes constant traversing of the axis. To compensate for the drift,
the compensation value is incremented/decremented step by step depend-
ing on the direction of the drift until the axis reaches zero speed.
Position-controlled axis
The drift causes a constant following error or position setpoint
,
0. To com-
pensate for the drift, the compensation value is incremented/decremented
step by step depending on the direction of the drift until following error or
position setpoint = 0 is displayed.
HMI Advanced:
Operating area switchover > Diagnosis > Service displays > Service
axis/spindle
!
Warning
If an axis is used for the function DSC (Direct Servo Control)
MD32640: STIFFNESS_CONTROL_ENABLE (dyn. stiffness control) = 1
drift compensation must not be enabled for that axis.
Drift compensation causes extreme speed fluctuations during switch-on/off of
the DSC function.
Table 10-36
Drift compensation: Machine data
Number
Identifier
Name/remarks
Ref.
Axis-specific ($MA_ ...)
36720
DRIFT_VALUE
Basic drift value
G2
Digital drives
ADI4
Manual
drift compensation
Machine data
10 NC Start-Up with HMI Advanced