06.03
13.3 Additional functions
13-421
Siemens AG, 2003. All rights reserved
SINUMERIK 840Di Manual (HBI) – 06.03 Edition
13.3
Additional functions
In conjunction with the measuring functions, another 2 axis-specific interface
signals are provided:
S
DB31-DBx, DBX61.0 “Drive test traversing request”
S
DB31-DBx, DBX1.0 “Drive test traversing enable”
In the PLC user program, this can be used in conjunction with measuring func-
tions to realize an additional axis-specific traversing enable.
The interface signals are activated from the main menu of the appropriate mea-
suring function in the group “Drive test traversing enable”. See Fig. 10-37,
page 10-395.
Fig. 13-1 Main menu: Position control loop measurement
Choose the type of traversing enable from the selection list either by using the
Toggle key or by clicking with the right mouse button on the desired enable
type:
–
Without PLC
Traversing of the axis to be measured is enabled depending on the
interface signals typical for JOG mode (servo enable, pulse enable, etc.).
Interface signals:
Drive test
Traversing
request,
Traversing enable
Activation
13 Drive Optimization using HMI Advanced