Communications
10.2 Acyclic data exchange
SIPLUS HCS4200 PROFINET/PROFIBUS DP
Operating Instructions, 07/2019, A5E35066204A/006
169
Data record 50 "Direct switching of the outputs"
The data set describes an HCS function and addresses the HCS.
Byte
Meaning
0 ... 25 !SETPOINT WITHOUT TRIGGER!
This data set can be used to disable the time scale with which the setpoints are activated in
the HCS (see section Half-wave control (Page 132)).
The process cannot be undone.
The definition takes place over an array [0...25] of the type char. The introductory text must
correspond exactly to the specification; otherwise the data record is rejected with an error
and is not executed.
10.2.2
Acyclic input data
The datasets/values described in section "Acyclic output data (Page 164)" can also be read.
Data record 100 "Field type 1"
One dataset of the maximum possible length (32 fields) is always returned. A non-assigned
field is entered as channel number 0.
Data record 101 to 132 "Field type 2"
One dataset of the maximum possible length (24 channels) is always returned. Unassigned
channels are entered as 0, the same applies to an unassigned field
Data record 150 "Production field value"
One dataset of the maximum possible length (32 fields) is always returned. Setpoint 0 is
entered for unused fields.
Summary of Contents for SIPLUS HCS Series
Page 1: ...SIPLUS HCS4200 PROFINET PROFIBUS DP ...
Page 2: ......
