i
i
NOTE
An exclamation point appears in the project tree before and during the routing and indicates an inconsis-
tent routing. At the end of an error-free routing, the exclamation point disappears automatically. If the
exclamation point does not automatically disappear, you can remove it by clicking the Check consistency
icon.
[scconsis-310812-01.tif, 1, en_US]
Figure 7-7
Checking Consistency
Instantiate Function Groups, Functions, and Function Blocks from the DIGSI 5 Library
²
Using Drag & Drop, move the voltage and current function groups from the DIGSI 5 library into the
project tree.
i
i
NOTE
This procedure also applies for the recorder functions Slow-scan recorder and Continuous recorder and
for the measured values Recorder routing with their associated measured value function blocks Routing f,
Routing I, Routing pwr and Routing V).
Fault Recorder
7.1 Introduction to DIGSI 5
SIPROTEC 5, Fault Recorder, Manual
219
C53000-G5040-C018-5, Edition 11.2017
Summary of Contents for SIPROTEC 5
