/PERATING INSTRUCTIONS
3*
6
# ' #
!S WITH EVERY SETTINGS OF THE DEVICE FOR WHICH CODE
WORD INPUT IS NECESSARY CODEWORD OPERATION MUST
BE TERMINATED 4HIS IS DONE BY USING THE KEY COMBI
NATION
& %
IE DEPRESSING THE FUNCTION KEY
&
FOL
LOWED BY THE ENTRY KEY
%
4HE DISPLAY SHOWS THE
QUESTION 3!6% .%7 3%44).'3 #ONFIRM WITH
THE 9ES KEY
*9
THAT THE NEW SETTINGS SHALL BE
COME VALID NOW )F YOU PRESS THE .O KEY
.
IN
STEAD CODEWORD OPERATION WILL BE ABORTED IE ALL AL
TERATIONS WHICH HAVE BEEN CHANGED SINCE THE LAST
CODEWORD ENTRY ARE LOST 4HUS ERRONEOUS ALTERATIONS
CAN BE MADE INEFFECTIVE
!DDRESS SHOWS THE ACTUALLY ACTIVE PARAMETER SET
5SE THE .O KEY
.
TO PAGE THROUGH THE ALTERNATIVE
POSSIBILITIES 4HE DESIRED POSSIBILITY IS SELECTED BY
PRESSING THE ENTER KEY
%
)F YOU SELECT
3%4 "9 ").).054
THEN THE PARAMETER
SET CAN BE CHANGED OVER VIA BINARY INPUTS SEE 3EC
TION
)F YOU SELECT
3%4 "9 ,3! #/.42
THEN THE PARAMETER
SET CAN BE CHANGED OVER VIA THE SYSTEM INTERFACE
3%4 "
!#4)6!4).'
3%4 !
!#4)6 0!2!-
3%4 !
3%4 "9 ").).054
3%4 "9 ,3! #/.42
2
.
n
m
n
#HANGE OVER OF THE ACTIVE PARAMETER
SET VIA BINARY INPUTS
)F CHANGE OVER OF PARAMETER SETS IS INTENDED TO BE
CARRIED OUT VIA BINARY INPUTS THE FOLLOWING IS TO BE
HEEDED
,OCALLY IE FROM THE OPERATOR PANEL OR FROM 0# VIA
THE OPERATING INTERFACE !#4)6!4).' MUST BE
SWITCHED TO
3%4 "9 ").).054
REFER TO 3ECTION
/NE LOGICAL BINARY INPUT IS AVAILABLE FOR CONTROL OF
THE PARAMETER SETS 4HIS BINARY INPUT IS DESIG
NATED
0ARAM3ELEC
&.O
4HE LOGICAL BINARY INPUT IS ALLOCATED TO A PHYSICAL
INPUT MODULE REFER TO 3ECTION IN ORDER TO AL
LOW CONTROL !N INPUT IS TREATED AS NOT ENERGIZED
WHEN IT IS NOT ASSIGNED TO ANY PHYSICAL INPUT
)F THE BINARY INPUT
0ARAM3ELEC
&.O
IS
SET IN NORMALLY OPEN MODE DF 3ECTION THE
FOLLOWING RESULTS FOR PARAMETER SET CHANGE OVER
NOT ENERGIZED
PARAMETER SET ! IS VALID
ENERGIZED
PARAMETER SET " IS VALID
4HE CONTROL INPUT SIGNAL MUST BE CONTINUOUSLY
PRESENT AS LONG AS THE SELECTED PARAMETER SET
SHALL BE ACTIVE
www
. ElectricalPartManuals
. com
