Mounting and dismantling
3.4 Connecting the 3RW5 HMI
SIRIUS 3RW50 soft starter
Manual, 09/2019, A5E35628455002A/RS-AA/001
63
●
Make sure that the locking switch on the rear of the 3RW5 HMI Standard is in the
required position.
For more information, see Chapter 3RW5 HMI Standard (Page 141).
●
Insert the push-in lugs into each side of the enclosure until you hear them engage
①
and
fix the 3RW5 HMI Standard on the wall
②
/
③
.
3.4.5
Installing the High Feature 3RW5 HMI on a flat surface
Requirements
●
Note the mounting positions, minimum clearances and ambient conditions stated on the
data sheet.
●
3RW5 HMI High Feature (accessories)
●
Level surface, e.g. sufficiently strong mounting plate
●
2 properly executed drill holes with thread or plugs on the level surface. Refer to the
drilling pattern (Page 197).
●
2 head screws M4 x 12 DIN ISO 7045 to fit the drill-holes
●
Screwdriver (depending on the drive of the screws)
●
2 push-in lugs (accessories) for wall mounting
●
HMI connecting cable (accessory) of suitable length connected to the soft starter
(Page 55)
