,/>@
W
If the measured value exceeds the limit of the scaling (200% in the example), the line extends
parallel with the x-axis and is displayed red in that area.
8.20.3
Monitoring the process image of the 3RW55 soft starter with the 3RW5 HMI
High Feature
Operating principle
The process image input (PII) contains current information about the soft starter and process
state. The process image output (PIQ) contains the current control commands to the 3RW55 or
3RW55 Failsafe soft starter. The control command states of the control source, which has control
priority according to the operating mode controller, are entered in the data memory of the
process image outputs. Note the overview of the process images in chapter Process data and
process images (Page 196).
Display on the HMI High Feature
• Menu: "Monitoring > Process image"
Display of the process images on the 3RW5 HMI High Feature
In the process image input (PII) and process image output (PIQ), you can see which bits of the
process image are active or inactive:
Check box
Status
Bit
inactive
0
active
1
Functions
8.20 Monitoring
SIRIUS 3RW55 and 3RW55 Failsafe Soft Starters
Equipment Manual, 02/2022, A5E35630887002A/RS-AF/006
231
