![background image](http://html.mh-extra.com/html/siemens/sirius-series/sirius-series_system-manual_383201065.webp)
Installation/Removal
8.1 Installing the SIRIUS 3RA6 compact starter and AS-i mounting module
SIRIUS 3RA6 Compact Starter
System Manual, 02/2008, GWA 4NEB 560 0601-02 DS 02
63
8.1.4
Installing the AS-i mounting module
Requirements
NOTICE
There is a risk of damage to the AS-i mounting module.
If you install the AS-i mounting module on a compact starter that has a control voltage of
more than 24 V, the AS-i mounting module will be supplied with too much power. This will
damage the AS-i mounting module.
Only install the AS-i mounting module on a compact starter with a control voltage of 24 V.
NOTICE
There is a risk of damage to the AS-i mounting module.
When installing the AS-i mounting module, please observe the ESD regulations, as
electrostatic charging can damage it.
●
The auxiliary and control conductor terminal blocks must be removed from the compact
starter (24 V) (for information on removing the auxiliary and control conductor terminal
blocks, please refer to "Installing/Removing auxiliary and control conductor terminal
blocks (Page 135)").
●
The compact starter must be switched off (actuator set to OFF position).
Procedure
Step
Instructions
Image
1
Insert the AS-i mounting module into the
mechanically coded guiderail on the
device from the bottom and then push it
back until you hear it engage.
1