FEC920: USER GUIDE
Page 30
A
September 18
Figure 16 Log in Menu
To log in as Engineer (default password = 100):
1.
Operate the up arrow key three times, to display ‘Engineer’.
2.
Press the scroll key to call the ‘alpha’ keyboard, with the letter ‘q’ highlighted.
3.
Use the down arrow key three times to highlight ‘Numeric’.
4.
Operate the scroll key to display the numeric keyboard (numeral ‘1’ highlighted.)
5.
Operate the scroll key to enter ‘1’, then use the up arrow key nine times to highlight numeral ‘0’ and use
the scroll key twice to enter ‘0’ 0’, completing the password of 100.
6.
Use the Page key to call the confirmation display.
7.
If the password entry is as required, use the up arrow twice (or the down arrow once) to highlight the word
‘Yes’ and operate the scroll key to confirm. The top level configuration menu appears. Otherwise, ‘Cancel’
can be used to clear the entry in order to start again, or ‘No’ can be used to quit login.
5.4 DISPLAY MODES
The following subsections describe the various display modes available to the user. By default, the ‘Home’
display mode is ‘Vertical Trend’, but this can be edited as a part of ‘Instrument.Display’ configuration (Section
6.1.3). This configuration area also allows the user to disable one or more display modes should they not be
required.
The current display mode can be chosen either by using the top level menu ‘Go to View’ item or, from any
display mode, by scrolling through the enabled modes using the up or down arrow buttons.
Details of the various display modes are to be found in the following subsections:
Access
Access
Logged out
Operator
Access
Supervisor
Access
Engineer
Access Engineer
Password
Password
Password
Accept changes
No
Yes
Cancel
Access
<User>
* If the Auditor feature is enabled,
the Operator user is not displayed. If
the Auditor feature is not enabled,
the <User> user is not displayed.
*
*
Vertical trend ................................... Section 5.4.1
Horizontal trend
...............................
Section 5.4.2
Vertical bargraph
.............................
Section 5.4.3
Horizontal bargraph
.........................
Section 5.4.4
Numeric ........................................... Section 5.4.5
Alarm panel
.....................................
Section 5.4.6
Modbus Master
................................
Section 5.4.7
EtherNet/IP
......................................
Section 5.4.8
A5E45696052A Rev-AA