FEC920: USER GUIDE
Page 72
September 18
Channels one to four in the configuration relate to An In 1 (terminals 1I, 1+ and
1-
) to An In 4 (terminals 4
I, 4+
and
4-
) respectively - see Figure 4, in Section “INSTALLATION” on page 9.
Figure 67 Channel main menu (expanded)
Descriptor
Allows a (20 character max.) descriptor to be entered for the channel. Some thought
should be given to ensure that the descriptor is meaningful because in some display
screens it is truncated. For example, ‘Furnace 1 area 1’ and ‘Furnace 1 area 2’ might both
appear as ‘Furnace 1 a’ and thus be indistinguishable from one another, except in
background color.
PV
Read-only. Displays the current value of the channel.
Note:
For the sake of completeness, the figure above shows all possible fields, even though many
are mutually exclusive. For example, ‘Test signal’ appears only when ‘Test’ is selected as
Type. It would never appear when Type = thermocouple (as shown). Similarly, ‘Shunt’ would
appear only for Type = mA.
Channel 1
Thermocouple
197.35
Good
Adjusted
2
°C
Descriptor
Type
PV
Status
IP Adjust State
Resolution
Units
Channel.1.Main
Triangle 5 Hr
0
10
2.49
Type K
0.00
100.00
°C
0.00
100.00
0.000
External
0.00
1.0 sec
Break High
Drive Low
1%
0.2
35.1
Test Signal
Input Low
Input High
Shunt
Lin Type
Range Low
Range High
Range Units
Scale Low
Scale High
Offset
CJ Type
Ext CJ Temp
Filter
Sensor Break Type
Fault Response
Sensor Break Val
Measured Value
Internal CJ Temp
A5E45696052A Rev-AA
