Siemens Sitrans LU-180, Operating Instructions Manual

Siemens AG 

Division Process Industries and Drives 

Postfach 48 48 

90026 NÜRNBERG 

GERMANY 

Document order number: A5E37100674 

Ⓟ

 03/2016 Subject to change 

Copyright © Siemens AG 2016. 

All rights reserved 

Legal information 

Warning notice system 

This manual contains notices you have to observe in order to ensure your personal safety, as well as to prevent 

damage to property. The notices referring to your personal safety are highlighted in the manual by a safety alert 

symbol, notices referring only to property damage have no safety alert symbol. These notices shown below are 

graded according to the degree of danger. 

DANGER 

indicates that death or severe personal injury will result if proper precautions are not taken. 

WARNING 

indicates that death or severe personal injury may result if proper precautions are not taken. 

CAUTION 

indicates that minor personal injury can result if proper precautions are not taken. 

NOTICE 
indicates that property damage can result if proper precautions are not taken. 

If more than one degree of danger is present, the warning notice representing the highest degree of danger will be 

used. A notice warning of injury to persons with a safety alert symbol may also include a warning relating to property 

damage. 

Qualified Personnel 

The product/system described in this documentation may be operated only by personnel qualified for the specific task 

in accordance with the relevant documentation, in particular its warning notices and safety instructions. Qualified 

personnel are those who, based on their training and experience, are capable of identifying risks and avoiding 

potential hazards when working with these products/systems. 

Proper use of Siemens products 

Note the following: 

WARNING 

Siemens products may only be used for the applications described in the catalog and in the relevant technical 

documentation. If products and components from other manufacturers are used, these must be recommended 

or approved by Siemens. Proper transport, storage, installation, assembly, commissioning, operation and 

maintenance are required to ensure that the products operate safely and without any problems. The permissible 

ambient conditions must be complied with. The information in the relevant documentation must be observed. 

Trademarks 

All names identified by ® are registered trademarks of Siemens AG. The remaining trademarks in this publication may 

be trademarks whose use by third parties for their own purposes could violate the rights of the owner. 

Disclaimer of Liability 

We have reviewed the contents of this publication to ensure consistency with the hardware and software described. 

Since variance cannot be precluded entirely, we cannot guarantee full consistency. However, the information in this 

publication is reviewed regularly and any necessary corrections are included in subsequent editions.