Cleaning and maintenance NL
Basic setting
Display text
Choise
Description
InfoLight
I01
1
I00 - I01
Turn InfoLight on or off. During the
program run, a light point is
projected on the floor under the
door of the appliance. The light point
is not visible with a high installation
in combination with a flush-fitting
furniture front. If the light point
flashes, the appliance door is not
completely closed. When the light
point on the floor is no longer
visible, the program is complete.
In position "I00" the InfoLight is
switched off.
Signal strength
b02
1
b00 - b03
Control the signal strength.
At position "b00" the sound signal
is switched off.
Factory setting
re
YES
Reset changed settings
to the factory state.
The settings for the first
start-up must be specified.
1
Factory setting (may differ depending on the device type)
Change basic settings
R
Cleaning and maintenance
cleaning and maintenance
1.
Open the appliance door.
to press.
3.
Approx. 3 seconds on
R
Carefully clean and maintain your
appliance to ensure that it continues to
work properly for a long time.
cleaning and maintenance
2.
on
Busy-
to access the basic settings.
Cleaning the rinse aid container
a The display shows Hxx.
reflected
a The display shows
to give.
WARNING
Risk of health hazard!
4.
Just as often on
to press
until the display shows the desired setting
ling indicates.
5.
Just as often on
The use of chlorinated cleaning
agents can lead to health damage.
▶
Never use chlorinated cleaning agents
using resources.
press to
the display shows the desired
value.
You can change several settings.
1.
Remove coarse soiling in the
interior with a damp cloth.
6.
To save the settings, press for
approx. 3 seconds.
7.
Close appliance door.
35