Rinse SystemNL
Overview of the consumption values
when regenerating the
softening system
2
Here you will find an overview of the
maximum additional run time and
consumption values when regenerating
the softening system.
Regenerating the softening
system after x washes
6
1
Additional running time in minutes
More water consumption in litres
More power consumption in kWh
7
5
0.05
2.
Top up the rinse aid up to the max
mark.
The stated consumption values are
laboratory measured values which
are determined according to the
currently valid standard and on the
basis of the Eco 50° program and the
factory-set water hardness value of 13
- 16 °dH.
max
G
G
lance flushing system
lance flushing system
G
s
lance flushing system
You can use dishes and glasses with
3.
If rinse aid has spilled over, it must
be removed from the rinse aid
container.
wash off without a hitch using the
rinse system and rinse aid.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
rinse aid
4.
Close the lid of the rinse aid
reservoir.
For optimal drying results it is best
to use the rinse aid.
Only use rinse aid for household
dishwashers.
aThe lid audibly clicks into place.
Set the rinse aid amount
Filling rinse aid
If the rinse aid refill indicator lights up,
add rinse aid. Only use rinse aid for
household dishwashers.
If streaks or water spots remain on the
dishes, adjust the amount of rinse aid.
1.
Press.
1.
The lip on the deck
rinse aid
know and lift
ell of it
servo press
†
2.
Approx. 3 seconds on
to access the basic settings.
Busy-
aThe display shows Hxx.
27