7
User programming via the keypad
User Menus
32
Siemens AB
A6V10271018
Security Products
26.09.2011
2. Press SELECT for the default name and number. Or enter a customized user
name and press SELECT.
There are 3 types of users available: STANDARD USER, LIMITED USER,
or MANAGER.
3. Scroll to the preferred type and press SELECT.
The system generates a default code for each new user.
4. Press SELECT to accept the default code. Or enter a new user code and press
SELECT.
The keypad confirms that the new user has been created.
7.1.9
CHANGE PIN
To change a PIN:
1. Scroll to CHANGE PIN and press SELECT.
A randomly generated PIN appears.
2. Select this new PIN or overwrite by entering a new PIN and press ENTER.
NOTICE
If the system is set for 5-digit PINs, a new 5-digit PIN must be entered. The
system will not accept a PIN with fewer numbers than it is set to receive.
1. Confirm the new PIN and press SAVE.
2. Press BACK to return to the previous screen to amend the PIN.
During the process if the display times out, the old PIN remains valid.
NOTICE
Where USER DURESS feature is enabled, consecutive user codes (i.e. 2906,
2907) are not permitted, as entering this PIN from the keypad would activate a
user duress event.
NOTICE
Engineer PINs should be noted down. If a PIN is forgotten, a factory default of the
system is required to reset PINs.
