Page
6
Document Number: 0072
Rev. 09
CONTROLLED COPY
4. MARKING
Siemens Subsea Connectors and Penetrators are marked with the Siemens Subsea part number
and unique serial number. Marking locations are typically on the Plug Nose and Receptacle Shroud
for Wet Mate Connectors and on the Flange of Penetrators. Figure 1 shows the typical marking
locations for a Plug and Receptacle. Marking is typically by laser etching.
Harnesses are also marked with the Siemens Subsea part number and unique serial number for the
harness as shown in Figure 2. Client and project specific information is also usually added to these
labels. Labels are typically black text on a yellow background underneath clear heatshrink. Typically,
labels are located at each end of the harness and also centrally.
Figure 1
– Marking of Connectors
Figure 2
– Marking of Hoses
Marking of Siemens Subsea Part No
and Serial No for individual
Connectors
Marking of Siemens
Subsea Part No, Serial
No and client information
on harnesses
Summary of Contents for SpecTRON 5
Page 1: ......