Installation and connection
aus
13
Saving energy
If you follow these instructions, your
appliance will use less electricity and
less water.
Use the Eco 45° programme.
The Eco 45° programme is en-
ergy-efficient and environmentally
friendly.
→
Change the sensor setting to the de-
fault.
Consumption is reduced.
→
AquaSensor
The AquaSensor is an optical meas-
uring device (light barrier) which
measures the turbidity of the rinsing
water. You can save water with the
AquaSensor.
Use of the AquaSensor depends on
the programme. If the soiling level is
high, the rinsing water is drained off
and replaced with fresh water. If the
soiling level is lower, the rinsing wa-
ter is used in the next wash cycle, so
reducing water consumption by 3-6
litres. In the automatic programmes
the temperature and run time are ad-
ditionally adjusted to the level of soil-
ing.
Sensors
The sensors adjust the programme
sequence and strength in the auto-
matic programmes depending on the
level and type of soiling.
The sensor has different sensitivity
settings that can be changed in the
basic settings.
→
Sensor setting
Description
Standard
Optimum setting for a
mixed load and heavily
soiled tableware. Saves
both energy and water.
Sensitive
Adjusts the programme
strength for effective re-
moval of food remnants
even with low soiling
levels. Energy and water
consumption are adjusted
accordingly.
Very sensitive
Adjusts the programme
strength for difficult condi-
tions of use, e.g. stubborn
dried-on food remnants.
Recommended setting
when using organic or eco-
logical detergents contain-
ing low levels of active
agents. Energy and water
consumption are adjusted
accordingly.
Installation and connection
Installation and connec-
tion
Installation and connection
Scope of supply
After unpacking all parts, check for
any damage in transit and complete-
ness of the delivery.
If you have any complaints, contact
the dealer who sold you the appli-
ance or our Customer Service.
Note:
The appliance has been tested
at the factory to check it is in working
order. It is possible that water has left
marks on the appliance. These
marks will disappear after the first
wash cycle.
The delivery consists of the following:
¡
Dishwasher
¡
Operating instructions