![background image](http://html.mh-extra.com/html/siemens/synova-fc330a/synova-fc330a_operating-manual_379198041.webp)
e1973c-8
02.2004
37
Fire & Security Products
Siemens Building Technologies Group
Functional test of manual call points
Test procedure for type KAC
1.
Set the desired zone into detector test mode (
page 34).
2.
Insert the test key into the opening at the lower left side of the housing.
A test alarm is simulated.
3.
Observe, whether the response indicator near the upper right corner of the housing flashes.
4.
Remove the test key.
The functional testing is completed.
"
If the tested manual call point did not respond, call the SIEMENS service organization.
Test procedure for type DIN (indirect activation)
1.
Set the desired zone into detector test mode (
page 34).
2.
Open the housing of the manual call point with the key.
3.
Press down the button completely.
A test alarm is simulated.
4.
Observe, whether the response indicator, a red LED to the right of the button, flashes.
5.
Close the housing.
The functional testing is completed.
"
If the tested manual call point did not respond, call the SIEMENS service organization.
Control console
Display shows
"
Each test alarm is indicated in the display for a few seconds and also registered in the event
memory.
Response
indicator
Test
−
key
Response
indicator
Button
mode ’detector TEST’ ACTIVE
> test−ALARM zone ###/##
WED 21.7.99 15:00
Summary of Contents for Synova FC330A
