Configuration
4.21 Creating telecontrol connections for the ST7 communication
TIM 1531 IRC
100
Operating Instructions, 02/2018, C79000-G8976-C468-02
2.
Select the starting point of the connection by double-clicking.
The connection will then be included in the list of telecontrol connections.
The name of the connection is preset, but you can change it.
3.
Now in the "Endpoint" box select the connection partner from the drop-down list.
Boxes with a missing or bad configuration are shown on a red background, in the example
the representation "TC_Connection_3".
Figure 4-6
"Network data" editor, "Telecontrol" tab
Specification of the connection sequence
Then specify the connection sequence of the created telecontrol connection.
1.
Above the second table "Configured connection paths" click the paths symbol
.
The dialog "Add connection paths" opens and the possible connection path are searched
for.
2.
Select one of the possible connection paths in the top table.
The connection path(s) are shown with details in the second table.
–
If several connections are displayed in the upper table, you can select one or two
redundant connections.
–
If no connection is displayed in the upper table, there is a configuration error in the
corresponding stations or networks.
In this case, close the dialog with the "Close" button and complete the configration.
