UTMC OTU/MOVA Handbook
667/HB/31601/000
Page 59
Issue 5
6.7 FAULT TABLE SCREEN
This screen displays currently active faults on the outstation and on monitored street
equipment. When the outstation is connected to an ST800/900 controller, the active
controller faults are displayed (i.e. as provided by the FFS controller command).
Entries can be made in the table by each running application. The applications currently
running are displayed on the ‘System’ screen.
Additional information on fault timing and fault history can be obtained by examination
of the ‘System Log’ screen and, in the case of ST800/900 etc. controllers, the
‘Controller Log’ screen.
Reload
Pressing ‘Reload’ will update the fault table information.
