en
Selecting additional functions
26
\
Selecting additional
functions
Selecting additional functions
Select the desired additional function
with the
menu (Option)
button, touch
this button until your desired option
frame flashes and then activate the
chosen option by touching the
modificar (Select)
button. The selection
bar appears at the bottom of the frame,
indicating that the option is selected.
Touch the
modificar (Select)
button
again to deactivate this option. You can
repeat operation to select more
additional functions which are available
for the selected programme. If there is
no other action, the function frame
stops flashing and comes on after
several seconds. The additional function
is sucessfully selected .
speedPerfect
á
(
For a shorter wash time with a
comparable washing effect to the
standard programme.
Note:
Do not exceed maximum load.
Overview of programmes
ecoPerfect
à
0
Energy-optimised washing by
reducing the temperature while
achieving a consistent washing result.
Note:
The washing temperature is
lower than the selected temperature.
For special hygiene requirements, it is
recommended that a higher
temperature be selected or the
speedPerfect
á
additional function.
Less iron
{
8
Special spin sequence with
subsequent fluffing. Gentle final spin –
residual moisture in the laundry
increased slightly.
Stains
@
The
Stains
additional function for
treating special stains can be selected.
A total of 6 different stains can be
selected. The washer dryer adjusts the
washing temperature, drum movement
and soaking time specifically to the type
of stain. Hot or cold water, gentle or
intensive washing control and long or
short soaking provide the wash
programme with a special sequence for
each type of stain. The result: the best
treatment for each stain.
Rinse plus
l
H
Additional rinse cycle. For areas
with very soft water or for an even better
rinsing result.
Note:
Select
Rinse plus
l
using the
menu (Option)
button. Then touch the
modificar (Select)
button to activate the
function and touch the
modificar
(Select)
button down for the desired
number of rinse cycles (max. 3 cycles,
depending on the selected
programmes).
2+3
l
: Default rinse cycle + additional
rinse cycle.
#
+