Cleaning and maintenance
en
29
Drain pump blocked
:
Warning
Risk of scalding!
Washing water is hot when washing at
high temperatures. You may be scalded
if you touch the hot washing water.
Allow the washing water to cool down.
1.
Turn the tap off to prevent more
water from flowing in and to ensure
that it is drained via the detergent-
solution pump.
2.
Turn the programme selector to
$
(Off)
. Pull out the mains plug.
3.
Open the service flap.
4.
Take the drainage hose out of the
holder.
5.
Remove the cover flap, draining the
washing water into a suitable
container. Press on the cover flap
and insert the drainage hose into the
holder.
Note:
Residual water may run out.
6.
Carefully unscrew the pump cover.
Clean the interior, pump cover
thread and pump housing (the fan
impeller in the detergent-solution
pump must be able to rotate).
7.
Reinsert and screw on the pump
cover. Handle should be vertical.
8.
Close the service flap. If required,
engage the disengaged service flap
beforehand.
Note:
To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser
II
and start the
0
(
Spin
)/
p
(
Empty
) programme.
Drainage hose on the siphon
blocked
1.
Turn the programme selector to
$
(Off)
. Pull out the mains plug.
2.
Loosen hose clip, carefully remove
drainage hose. Residual water may
run out.
3.
Clean drainage hose and siphon
spigot.
4.
Re-attach the drainage hose and
secure the connection point with the
hose clip.
Filter in the water inlet hose
blocked
:
Warning
Danger of death!
Do not immerse Aqua-Stop safety
device in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme (except
0
(
Spin
)/
p
(
Empty
).
3.
Select
inicio
/pausa+carga (
Start
/
Reload)
!
. Allow the programme to
run for approx. 40 s.
4.
Turn the programme selector to
$
(Off)
. Pull out the mains plug.
