en
Faults and what to do about them
32
Information on the display panel
Display
Cause/Remedy
A:01
Close the door immediately because of the rising water level. If an interruption
occurs,
A:01
and
OPEN
are displayed alternately.
A:02
The door is locked for safety reasons (water level and/or temperature too high).
■
Washing programme:
In pause mode,
A:02
and
PAUS
are displayed
alternately. If you need to open the door, wait for the temperature to drop or
drain the water ( e.g. select
0
(
Spin
)/
p
(
Empty
)).
■
Drying programme:
If you have to open the door, wait until the tempera-
ture has dropped slightly or set the drying programme to 15 min to cool
down the laundry.
If
A:02
is frequently displayed at the end of the drying programme:
■
■
Run the
retirar pelusas/fios (Fluff Clean)
cold
programme without laun-
dry.
A:03
Door cannot be locked/unlocked due to high temperature of door lock. Keep
the washer dryer switched on for about 1 min. Or switch off then switch on to
any programme. The washer dryer can then be locked/unlocked again.
hot
The door cannot be opened after the drying programme due to the high temper-
ature. The cooling down process will continue until the display disappears and
the door can be opened.
|
■
Flashes
(no water supply): Tap turned on? Inlet filter blocked? Clean the
inlet filter
Supply hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not extend
the programme duration.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª
■
Hold down button
secar (Drying)
Ù
for 3 s to clear this display.
■
Clean the air inlet filter
■
Run the
retirar pelusas/fios (Fluff Clean)
programme without laundry.
LO kg
,
HI kg
Laundry amount information. On when drying phase finished.
LO kg
: Signals a small load for drying,
HI kg
: Signals a very high load for drying.
Other displays
Turn the programme selector to
$
(Off)
. The appliance is switched off.
Wait 5 s and switch on again. If the display is indicated again, call customer
service.