en
Installation and connection
38
■
When lifting the washer dryer by its
projecting parts (e.g. washer dryer
door), the parts may break off and
cause injuries.
Do not lift the washer dryer by its
projecting parts.
Installation area
Note:
Stability is important to prevent
the washer dryer from wandering!
■
The installation area must be firm
and level.
■
Soft floors and floor coverings are
not suitable.
■
To ensure good drying results,
ensure that the room is well
ventilated.
Installing the appliance on
a base or on a wooden joist
ceiling
Caution!
Damage to the appliance
The washer dryer may wander during
the spin cycle and topple or fall off its
base.
Always secure the washer dryer feet
with holding brackets.
Holding brackets: order no.
WMZ 2200, WX 975600, CZ 110600,
Z 7080X0.
Note:
If installing on a wooden joist
ceiling:
■
If possible, install the washer dryer in
a corner.
■
Screw water-resistant wooden board
(min. 30 mm thick) to the floor.
Installing the appliance under/
between kitchen units
:
Warning
Risk of electric shock!
Danger of death if live parts are
touched.
Do not remove the appliance cover.
Build under/build in before connection
to the power supply.
:
Warning
Risk of scalding!
During the drying phase, warm air is
emitted at a temperature of
up to 60 °C.
Notes
■
Required dimensions:
a = 650 mm
b = 620 mm
c = 850 mm
■
Only install the washer dryer under a
continuous worktop connected firmly
to the adjacent cupboards.
■
Ventilate the installation area well,
otherwise the optimum drying results
will not be achieved. Dimensions of
the ventilation openings (to be
provided on one side, depending on
the circumstances). Opening cross-
section: d x e = 200 mm x 100 mm.
Height above floor: f = 365 mm.
Distance between wall and
appliance: 50 mm.
D
E
F
I
G
H