Installation and connection
en
43
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
retirar pelusas/fios
(
Fluff Clean)
programme the first time
without
laundry.
Note:
■
The washer dryer must have been
installed and connected properly.
Installation and connection
■
Never switch on a damaged
machine.
Inform your customer service
1.
Insert mains plug.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the washing machine door.
Do not load any laundry.
5.
Select the
retirar pelusas/fios
(
Fluff
Clean)
40°C
programme.
6.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
dispenser
II
.
8.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent frothing, use only
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9.
Close the detergent drawer.
10.
Select
inicio
/pausa+carga
(
Start
/Reload)
!
.
11.
When the programme ends, switch
off the appliance.
Your washer dryer is now ready for
use.
Transportation
Preparatory work
1.
Turn off the tap.
2.
Release the water pressure in the
supply hose.
Filter in the water inlet hose blocked
3.
Drain any residual washing water.
Drain pump blocked
4.
Disconnect the washer dryer from
the power supply.
5.
Remove the hoses.
Installing the transportation protection
devices:
1.
Remove the covers and keep in
a safe place.
If required, use a screwdriver.
2.
Insert all 4 sleeves.
Clamp the mains cable on the
holders. Insert and tighten the bolts.
Before switching on the appliance:
Notes
■
Always
remove the transportation
protection devices!
■
To prevent unused detergent from
flowing into the outlet during the next
wash: Pour 1 litre of water into
dispenser
II
and start the
0
(
Spin
)/
p
(
Empty
) programme.