en
Changing programme default settings
24
Starching
Note:
The laundry should not be
treated with fabric softener.
Liquid starch can be used in all wash
programmes. Pour starch into the
dispenser
M
according to
manufacturer’s specifications
(if required, clean beforehand).
Dyeing/Bleaching
Dye in household quantities only. Salt
may attack stainless steel! Observe
specifications of the dye manufacturer!
Do not
bleach laundry in the washer
dryer!
Soaking
1.
Pour soaking agent/detergent into
compartment
II
in accordance with
the manufacturer's instructions.
2.
Set the programme selector to
algodón/algodão (Cottons) 30 °C
programme.
3.
Select
inicio
/pausa+carga (
Start
/
Reload)
!
.
4.
After approx. ten minutes, select
inicio/
pausa+carga
(Start/
Reload
)
!
.
5.
After the required soaking time,
select
inicio
/pausa+carga (
Start
/
Reload)
!
again to continue or
change the programme.
Notes
■
Load laundry of the same colour.
■
No additional detergent is required;
the soaking solution is used for
washing.
0
Changing programme
default settings
Changing programme default settings
You can change the default settings for
selected programmes. The default
settings can be changed even while the
selected programme is running. The
effects depend on the progress of the
programme.
temp.°C (Temperature)
(
The indicated washing temperature
can be changed. The maximum
selectable washing temperature varies
depending on the selected programme.
Overview of programmes
0
(Spin speed)
0
The spin speed can be changed
before and during the programme (in
rpm, revolutions per minute) depending
on the progress of the programme.
Setting
– – –
(
Rinse stop
= without final
drain/spin cycle), laundry remains in the
water after the last rinse cycle. The
maximum spin speed depends on the
programme and model.
Overview of programmes
#