Installation and connection
en
37
5
Installation and
connection
Installation and connection
Standard accessories
Note:
Check the machine for transport
damage. Never use a damaged
machine. If you have any complaints,
contact the dealer from whom you
purchased the appliance or our
In addition
, a hose clamp (24 - 40 mm
diameter, available from specialist
dealers) is required to connect the
water drain hose to a siphon.
Useful tools
■
Spirit level for aligning
■
Spanner with:
– WAF13 for loosening the
transport braces, and
– WAF17 for aligning the appliance
feet
Secure installation
:
Warning
Risk of injury!
■
The washer dryer is heavy. Take
care when lifting it.
■
When lifting the washer dryer by its
projecting parts (e.g. washer dryer
door), the parts may break off and
cause injuries.
Do not lift the washer dryer by its
projecting parts.
■
If the hoses and power cables are
installed incorrectly, there is a risk of
stumbling and injury.
Lay hoses and cables in such a way
that there is no risk of stumbling.
Caution!
Damage to the appliance
■
Frozen hoses may tear or burst.
Do not install the washer dryer
outdoors and/or in an area where
there is a risk of frost.
(
Mains cable
0
Bag:
■
Installation and operating
instructions
■
Customer services location
directory*
■
Warranty*
■
Cover caps for openings after
the transport braces have
been removed
8
Water supply hose on Aqua-Stop
models
3
+
#
@
Water drain hose
H
Elbow for securing the water
drain hose*
P
Water supply hose on standard/
Aqua-Secure models
*
depending on the model