NL Troubleshooting
Malfunction
Program does not start.
Cause and Troubleshooting
1.
Open the door again.
2.
Remove trapped laundry.
3.
Close the door.
4.
To start the program, press Start/Refill.
Door cannot be
opened.
is activated.
▶
Resume the program by Centrifuge or Drain to
choose and press Start/Reload to push.
"Resume program at rinse hold", page 34
Temperature is too high.
▶
Wait for the temperature to drop.
▶
Water level is too high.
▶
Select a suitable program for draining.
Power cut.
▶
Open the door with the emergency release.
Washing water is not
pumped out.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
Drain pump is clogged.
▶
"Cleaning the drain pump", page 36
is activated.
▶
Resume the program by Centrifuge or Drain to
choose and press Start/Reload to push.
"Resume program at rinse hold", page 34
Water drain hose is connected too high.
▶
Install the water drain hose at a maximum height of 1
meter.
Pump cover not assembled correctly.
▶
Assemble the pump cover correctly.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
42
Summary of Contents for WG56G2M7NL
Page 18: ...NL Set up and connect 2 Check the mains plug for tightness 18 ...
Page 53: ......
Page 54: ......
Page 55: ......