Siemens WK12D321EE, Instruction Manual And Installation Instructions

23

Drying result not 

satisfactory.

The laundry clings to the sides of the 

drum after being spun.

Loosen up the laundry by hand; start 

the drying programme 

→

 page

17.

Closed tap

Maximum load exceeded.

Drying time selected too short.

Turn on the tap.

Reduce the load for the programme 

accordingly 

→

 page

30.

Select the drying time according to the 

load and the type of fabric.

Maximum or minimum load not taken 

into account 

→

 page

30

Once the programme has ended: 

adjust the load quantity, select a 

suitable drying programme and restart.

The fabric softener is not 

completely flushed in or too 

much water remains in the 

compartment

i

The fabric softener compartment insert 

is not correctly attached or is blocked.

Clean the fabric softener compartment 

insert and fit it correctly in the 

compartment

i 

→

 page

19.

The laundry is not dried.

The tap is turned off.

Turn on the tap.

The laundry load is too large.

Reduce the amount of laundry.

The drying time is too short.

Select a suitable drying time.

No messages on the display 

panel.

Power failure.

The programme continues when power 

is restored. If you wish to remove the 

laundry during a power cut, you must 

first drain out the water 

→

 page

20.

Check whether:

– the plug is plugged into the socket 

correctly.

– the circuit breaker (fuse) has tripped; 

if it has, call the after-sales service 

→

 page

24.

The door cannot be 

opened.

$

 (Rinse stop)

 is selected.

Select the programme 

+ 

+ centrifug. 

0

(Empty + Spin

 and press 

inicio

/pausa 

(

Start

/Pause).

The programme is running or the door 

is locked for safety reasons.

Wait until 

 appears on the 

display panel.

Power failure.

Unlock the door mechanically.

Emergency unlock.

In order to unlock the door mechanically in the event of a power failure, you will 

have to:



turn the programme selector to 

o

 (Off) and unplug the mains plug from the 

socket.



open the base panel and drain out the water 

→

 page

20.



pull the emergency release downwards and open the door at the same time.

– Before opening the door, make sure that there is no water or hot detergent 

solution in the washer dryer.

Under no circumstances open the door with the emergency release while the 

drum is still turning.

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to 

o

 (Off) and unplug the mains plug from the socket.

– Turn off the tap and call the after-sales service

→

 page

24.